WATER LEAK AT FRONT FLOOR ’02 –’06 Toyota Camry (TMMK), ’04 –’06 Toyota...
download Some customers may experience a water leak at the front floor area. Water may be Introduction entering the body due to a body sealer void on the engine compartment rear wall, near the upper...
View Article1998 – 1999 Toyota Camry & Toyota Solara inoperative Vapor Pressure Sensor 3...
download Introduction Under certain driving conditions, some 1998 – 1999 model year Camry and Solara vehicles may exhibit a M.I.L. “ON” with DTCs P0440, P0441 and P0446 stored due to an inoperative...
View Article2010-2011 Cadillac Escalade Active Fuel Management (AFM) Engine, Valve Lifter...
download Condition Some customers may comment on an engine valve lifter tick noise that occurs after the engine has been shut off for at least two hours. The tick noise may last from two seconds to ten...
View Article2001 Ford F-150 Cylinder Head DISASSEMBLY AND ASSEMBLY
download Cylinder Head Special Tool(s) Compressor, Valve Spring 303-567 (T97P-6565-AH) Spacer, Valve Spring Compressor 303-382 (T91P-6565-AH) Installer, Valve Stem Oil Seal 303-383 (T91P-6571-A)...
View Article1998 Ford Expedition Main Control Valve Body Removal Installation
download 1. If equipped, turn the air suspension switch OFF. 2. Disconnect battery ground cable. 3. Raise and support the vehicle; refer to Section 100-02. 4. Drain transmission fluid and remove the...
View Article2001 Ford Escort Cylinder Head Disassembly
download 1. Remove the bolt and the camshaft position (CMP) sensor. 2. Remove the bolts, the rocker arm seats, and the rocker arms. 2. Remove the bolts, the rocker arm seats, and the rocker arms. 3....
View Article2001 Chevrolet Cavalier Idle Air Control Motor (IAC): Service and Repair...
download 1. Remove the idle air control (IAC) valve connector. 2. Remove the IAC valve attaching screws (1). NOTE: If the IAC valve has been in service: DO NOT push or pull on the IAC valve pintle. The...
View Article1996 Ford Taurus valve body Removal and Installation
download REMOVAL NOTE: The oil pump and valve body are removed as an assembly. 1. Disconnect battery ground cable, then remove battery, battery tray, and remote air cleaner. 2. Position supply hoses,...
View Article1995 Ford Windstar VALVE CLEARANCE ADJUSTMENT
download NOTE: Hydraulic valve lifters are used; no valve adjustment is required. When valve and/or valve seat is machined, valve clearance is reduced and may cause improper valve operation. Different...
View Article1992 Suzuki Swift VALVE CLEARANCE ADJUSTMENT
download NOTE: Samurai & Sidekick 1) Remove rocker cover. Rotate crankshaft until zero degree (TDC) timing mark of timing belt cover is in line with timing mark on crankshaft pulley. 2) Cylinder...
View Article
